Installation - Switch - EVAP System Monitor

The following illustrations display a TYPICAL EVAP Canister and a typical ESIM switch. After installing any ESIM switch, the electrical connector on the switch must be in the 3 O'clock position. This step must be done for proper ESIM switch operation. 

Fig 1: Identifying ESIM Switch, O-Ring And EVAP Canister Opening

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

1. Be sure O-ring (2) and EVAP canister opening are clean.
   Fig 2: Identifying EVAP Canister, ESIM Switch And Electrical Connector

   Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
   CAUTION: The electrical connector (3) on the ESIM switch must be in 3 O'clock position after installation. This step must be done for proper switch operation.
2. Position ESIM switch (2) into EVAP canister (1) and rotate until electrical connector is in 3 O'clock position (3).
3. Connect electrical connector.
4. Connect plastic lines to ESIM switch.