LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2007 >> Raider SE >> Repair and Diagnosis >> Engine Mechanical >> Auxiliary Emission Control Systems >> Engine And Emission Control >> Servo - Speed Control >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Servo - Speed Control: Installation

Fig 1: Identifying Mounting Nuts, Servo Cable Sleeve, Servo And Cable Retaining Clip
G04853514Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  1. Position servo (2) to mounting bracket.
  2. Align hole in cable connector with hole in servo pin. Install cable-to-servo retaining clip (3).
  3. Insert servo mounting studs through holes in servo mounting bracket.
  4. Install two servo-to-mounting bracket nuts (1) and tighten to 7 N.m (60 in. lbs.).
    Fig 2: Identifying Speed Control Servo Components
    G04853512Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
  5. Position servo assembly (6) to inner fender and install three screws (3). Tighten 3 screws to 4 N.m (30 in. lbs.).
  6. Connect vacuum line (1) to servo.
  7. Connect electrical connector (5) to servo.
  8. Connect servo cable (2) to throttle body. (Refer to INSTALLATION ).
  9. Install air filter housing assembly.
  10. Connect negative battery cable to battery.
  11. Before starting engine, operate accelerator pedal to check for any binding.
scientia non olet · About LEMON Manuals