September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Alignment Of Liftgate Latch And Liftgate Striker
- Remove the rear end trim (Refer to
TRIMS
).
- If the striker and latch do not align properly, replace the striker and striker installation bolts with replacement parts (striker: MR523105, striker installation blot: MU000474).
- Tighten the bolts and move the replaced striker forward and backward or to the left and right to adjust.
- After adjusting, tighten the bolts to the specified torque [24 +/- 4 N.m (18 +/- 3ft-lb)].
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
NOTE:
If the bolt head interferes with the rear end trim, remove the interference area with a round file.