Section 24 (Basic Brake System -- Except Evolution)
WARNING: This page is about a different variant/trim than selected.
- General Description
- Basic Brake System Diagnosis
- Introduction To Basic Brake System Diagnosis
- Basic Brake System Diagnostic Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Vehicle Pulls to One Side when Brakes are Applied < Vehicles with Rear Drum Brakes >
- INSPECTION PROCEDURE 1: Vehicle Pulls to One Side when Brakes are Applied < Vehicles with Rear Disc Brakes >
- INSPECTION PROCEDURE 2: Insufficient Braking Power < Vehicles with Rear Drum Brakes >
- INSPECTION PROCEDURE 2: Insufficient Braking Power < Vehicles with Rear Disc Brakes >
- INSPECTION PROCEDURE 3: Increased Pedal Stroke (Reduced Pedal-to-Floor Board Clearance)
- INSPECTION PROCEDURE 4: Brake Drag < Vehicles with Rear Drum Brakes >
- INSPECTION PROCEDURE 4: Brake Drag < Vehicles with Rear Disc Brakes >
- INSPECTION PROCEDURE 5: Scraping or Grinding Noise when Brakes are Applied
- INSPECTION PROCEDURE6: Squealing, Groaning or Chattering Noise when Brakes are Applied
- INSPECTION PROCEDURE 7: Squealing Noise when Brakes are not Applied
- INSPECTION PROCEDURE 8: Groaning, Clicking or Rattling Noise when Brakes are not Applied.
- Special Tools
- On-Vehicle Service
- Brake Pedal Check And Adjustment
- Brake Booster Operating Test
- Check Valve Operation Check
- Proportioning Valve Function Test < Vehicles Without Abs >
- Bleeding
- Brake Fluid Level Sensor Check
- Front Disc Brake Pad Check And Replacement
- Disc Brake Rotor Check
- Brake Disc Thickness Check
- Front Brake Disc Run-Out Check And Correction
- Brake Lining Thickness Check
- Brake Drum Inside Diameter Check
- Brake Lining And Brake Drum Contact Check
- Auto Adjuster Function Check
- Master Cylinder Function Check
- Brake Pedal
- Master Cylinder Assembly And Brake Booster
- Front Disc Brake Assembly
- Rear Drum Brake
- Rear Disc Brake Assembly
- Specifications