LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 2003 >> Lancer Evolution >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycle Procedures >> 2002-03 Lancer, Montero & 2003 Outlander >> Pattern 14 >> Test Procedure
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Test Procedure

  1. Start the engine with all the accessories switched OFF.
  2. Accelerate with throttle position sensor output more than 4.2 volts for 5 seconds. (During the monitor)
  3. Stop at safe place and turn the ignition switch to "LOCK" (OFF) position.
  4. Start the engine and do Steps 1 to 3 again.
  5. Confirm that the diagnostic trouble code (DTC) is not output.
scientia non olet · About LEMON Manuals