Section 2 (Overhaul - 2.4L Engine)
WARNING: This page is about a different variant/trim than selected.
- Special Tools
- Generator And Ignition System
- Timing Belt
- Removal And Installation
- Notes
- Removal Service Points
- Installation Service Points
- >> A << Camshaft Sprocket Installation
- >> B << Engine Support Bracket Installation
- >> C << Crankshaft Sprocket "B" Installation
- >> D << Spacer Installation
- >> E << Counterbalance Shaft Sprocket Installation
- >> F << Timing Belt "B" Installation
- >> G << Crankshaft Sensing Blade/Crankshaft Sprocket/Crankshaft Pulley Washer/Crankshaft Bolt Installation
- >> H << Oil Pump Sprocket Installation
- >> I << Auto-TENSIONER Installation
- >> J << Timing Belt Installation
- Inspection
- Removal And Installation
- Fuel And Emission Parts
- Intake Manifold
- Exhaust Manifold
- Rocker Arms And Camshaft
- Cylinder Head And Valves
- Front Case And Oil Pump
- Removal And Installation
- Notes
- Removal Service Points
- Installation Service Points
- >> A << Right Counterbalance Shaft Rear Bearing Installation
- >> B << Left Counterbalance Shaft Rear Bearing Installation
- >> C << Counterbalance Shaft Front Bearing Installation
- >> D << Counterbalance Shaft Oil Seal Installation
- >> E << Oil Pump Oil Seal Installation
- >> F << Crankshaft Front Oil Seal Installation
- >> G << Oil Pump Driven Gear/Oil Pump Drive Gear Installation
- >> H << Oil Pump Case Assembly/Oil Filter Bracket Installation
- >> I << Flange Bolt Installation
- >> J << Plug Installation
- >> K << Oil Pan Installation
- >> L << Drain Plug Gasket Installation
- >> M << Oil Filter Installation
- >> N << Sealant Application To Oil Pressure Switch
- Inspection
- Removal And Installation
- Piston And Connecting Rod
- Crankshaft And Cylinder Block
- Specifications