CLOCKSPRING Test

If clockspring fails any check, replace with a NEW clockspring.

1. Check connectors and protective tube for damage and deformities.
2. Visually check case for damage or deformities.
3. Continuity should be present between the following connectors and terminals:
   • Connector No. 1, terminal No. 1 and connector No. 4, terminal No. 2.
   • Connector No. 1, terminal No. 2 and connector No. 4, terminal No. 1.
   • Connector No. 1, terminal No. 3 and connector No. 3. See Fig 1 .
4. Align paint mark on SRS connector No. 4 with notch in clockspring connector No. 2 and join connectors. See Fig 2 . Using a DVOM, check for continuity between terminals No. 22 and 23 at SRS Test Harness (MB991613) connector No. 5.

Fig 1: Identifying Clockspring Connectors

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA

Fig 2: Identifying SRS Harness Connectors

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA