LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mitsubishi >> 1992 >> Eclipse Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests >> Emission Systems & Sub-Systems >> Fuel Evaporation >> Purge Control Solenoid Valve (Turbo)
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Purge Control Solenoid Valve (Turbo)

  1. Remove Red-striped hose at purge control solenoid valve, mounted to firewall, left of master cylinder. Connect a hand vacuum pump to solenoid nipple. Apply vacuum to solenoid valve. Vacuum should not hold.
  2. Disconnect solenoid valve electrical connector. With vacuum applied to solenoid valve, apply battery voltage across connector terminals. Vacuum should hold when voltage is applied. Using an ohmmeter, check resistance across solenoid terminals. Reading should be 36-44 ohms at 68°F (20°C). If reading is not within specification, replace valve.
scientia non olet · About LEMON Manuals