Power Liftgate Initialization Procedure

WARNING: This page is about a different car, the 2008 Mercury Sable, 2008 Ford Taurus X, and 2008 Ford Taurus. However, it is still accessible from the selected car via links, so may be relevant.

If the LTM loses the logic battery supply for any reason, such as battery disconnect, module disconnect or if left open for more than 6 hours, the LTM will lose the power liftgate position stored in memory and will attempt to open when the liftgate switch is pressed the first time.

The power liftgate can also lose position if the following components are removed, adjusted or disconnected:

Power liftgate motor
Liftgate hinges
Power liftgate rod
Liftgate striker

The power liftgate normal operation will not be restored until the power liftgate position is once again stored into memory. The initialization procedure is the learning process the LTM uses to restore the power liftgate position in memory. The LTM monitors the position sensor data received during the initial power open-and-close operation to learn the position.

Refer to Power Liftgate Initialization .