Remote Keyless Entry System - Intermittent Operation (96-13-9)

WARNING: This page is about the Villager GS, Van Cargo, which is a different variant/trim than selected.

Publication date: 1996-06-17
Reference number: 96-13-9

REMOTE KEYLESS ENTRY SYSTEM - INTERMITTENT OPERATION

TECHNICAL SERVICE BULLETIN

Reference Number(s): 96-13-9, Date of Issue: June 17, 1996

REMOTE KEYLESS ENTRY SYSTEM - INTERMIT OPERATION

APPLICATION

Model(s): 1996 Mercury Villager

Bulletin No.: 96-13-9

Date: June 17, 1996

ISSUE

The remote keyless entry system may work intermittently. This may be due to the antenna being too short and not having good reception.

ACTION

Replace the keyless entry system antenna. The revised antenna is longer to improve reception and reduce the possibility of intermittent operation. Refer to the following SERVICE PROCEDURE for details.

SERVICE PROCEDURE

1 Remove the RH side A-pillar moulding.

Disconnect the remote keyless entry antenna in-line connector.
Install the new remote keyless entry antenna (F6XZ-15603-AA). Install foam tape over the windshield antenna pigtail to prevent rattles.
Run the new antenna wire along the outside of the A-pillar in such a way that it is hidden when the A-pillar trim is reinstalled. At the top of the A-pillar, route the antenna underneath the headliner toward the middle of the vehicle.
NOTE: Approximately 30.5 cm (12") of antenna will be underneath the headliner. Hold the wire in place by taping it to the headliner at the end of the wire.
Reinstall the A-pillar trim.
Verify operation of the keyless remote entry system.

PARTS INFORMATION

Part Number	Part Name
F6XZ-15603-AA	Antenna

WARRANTY INFORMATION

WARRANTY STATUS: Eligible Under The Provisions Of Bumper To Bumper Warranty Coverage.

OPERATION: 961309A

DESCRIPTION: Replace Remote Keyless Entry Antenna.

TIME: 0.3 Hr.

DEALER CODING: BASIC PART NO.: 15603

CONDITION CODE: 11

OASIS CODES: 112450