LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2025 >> Sprinter 3500XD Van Cargo Extended, 4WD >> Repair and Diagnosis (Single Page) >> External Pages >> Different car >> Section 3085 (Electronic Control Modules (Service Information)) >> Module, Keyless Ignition Node (Kin) >> Removal And Installation >> Removal And Installation >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Removal And Installation: Installation

WARNING: This page is about a different car, the 2018 Fiat 500X. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

For mechanical key ignition,

Refer to SWITCH, IGNITION, REMOVAL AND INSTALLATION .

  1. Position the KIN, then install and securely tighten the screws.
  2. Connect the KIN wire harness connector.
  3. Install the lower steering column cover.
  4. Turn the steering wheel to the middle position and secure it with the position lever.
  5. Install the instrument cluster bezel to the instrument panel. Refer to BEZEL, INSTRUMENT CLUSTER, REMOVAL AND INSTALLATION .
  6. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals