Weld In Spring Bracket Of Rear Axle Spring - Ar61.25-D-6155-03TS

	The high voltage used for electric welding presents a lethal hazard. Risk of explosion  from welding in areas close to highly highly inflammable materials. Risk of injury  from weld splatter and UV-light when welding. Risk of poisoning  from inhaling welding gases	Use insulating mats. Wear protective clothing, safety glasses and a protective mask. Remove inflammable materials from the hazard area. Use air extraction system.	AS00.00-Z-0007-01A
	Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts	Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.	AS00.00-Z-0017-01A
	Measures for preventing damage to vehicles or components when performing electric welding work		AH00.00-N-0005-01A
	000 588 02 84 00 Welder		WS60.00-P-0022K

Model 907.1/2 

The next steps are shown on the left side of the vehicle for model 907.233 and must be performed in a similar way in the event of damage on the right side of the vehicle.

1. Install lower section of spring bracket (1), fit, and fix in place.
2. Lower section of spring bracket (1) (areas B and C).
3. Lower section of spring bracket (1) (areas E and I).
4. Model 907.1/2 Lower section of spring bracket (1) (areas F, G, and H).
5. Install upper section of spring bracket (2), fit, and fix in place.
6. Upper section of spring bracket (2) (areas M and N).
7. Upper section of spring bracket (2) (areas A, P, and O).
8. Clean weld joints.