LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2023 >> Sprinter 2500 Van Crew, Eng CD 274.920 >> Repair and Diagnosis >> External Pages >> Different car >> Section 3085 (Electronic Control Modules (Service Information)) >> Module, Body Control (BCM) >> Removal And Installation >> Right Hand Drive >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Right Hand Drive: Installation

WARNING: This page is about a different car, the 2018 Fiat 500X. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check that the Body Computer assembly is not damaged.
  2. Connect the electrical connections on the rear side of the assembly.
  3. Put the body computer unit in its position and engage the retainers to the bracket.
  4. Connect the electrical connections on the front side of the assembly.
  5. Install the cowl trim panel. Refer to PANEL, COWL TRIM, REMOVAL AND INSTALLATION .
  6. Install the steering column opening cover. Refer to COVER, STEERING COLUMN OPENING, REMOVAL AND INSTALLATION .
  7. Connect the negative battery terminal.
  8. Perform BCM programming.
NOTE:

If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to determine if alignment of the PROXI configuration data into the new ECU is needed. If PROXI alignment is needed, follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under the Body Control Module (BCM) Miscellaneous Functions menu.

scientia non olet · About LEMON Manuals