Prepare Spring Bracket Of Rear Axle Spring For Installation - Ar61.25-D-6155-02TSC

Risk of injury  caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. Deburr repair panels.

AS00.00-Z-0017-01A

Model 907.6/7 with code IR2 (Wheelbase 3250 mm) 

The next steps are shown on the left component part and must be performed analogously on vehicles with damage on the right side of the vehicle.

1. Grind mating surfaces in crosshatched areas down to bare metal on the spring bracket (1).

   Commercially available devices/tools  Rotary wire brush

2. Remove shavings.

Commercially available devices/tools  Wet and dry vacuum cleaner