LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2022 >> Sprinter 2500 Van Cargo, 2.1L Eng >> Repair and Diagnosis >> External Pages >> Different car >> Section 3190 (Electronic Control Modules (Service Information)) >> Module, Emergency Assistance (EAM) >> Removal And Installation >> Emergency Assistance Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Emergency Assistance Module: Removal

WARNING: This page is about a different car, the 2020 Chrysler Voyager and 2020 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
GC0177812Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the Integrated Center Stack (ICS) from the instrument panel cover. Refer to CONTROLS, REAR CABIN COMFORT (RCCC)., REMOVAL AND INSTALLATION MODULE, INTEGRATED CENTER STACK (ICSM), REMOVAL AND INSTALLATION .
    GC0178283Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the instrument panel wire harness connector (4) and antenna connectors (3) from the Emergency Assistance Module (EAM) (2).
  4. Remove the four screws (1) from the EAM mounting bracket that secure the EAM (2) to the bracket.
  5. Remove the EAM (2) from the vehicle.
scientia non olet · About LEMON Manuals