Remove/Install Engine Oil Fill Level Sensor - Ar18.40-D-5116TSV
Engine 642 in model 907
| Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | AS00.00-Z-0010-01A | |
| Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. Do not fill engine oil into beverage containers. |
AS18.00-Z-0001-01A | |
| Remove/install | |||
| 1 | Raise vehicle | AR00.60-D-1000-04TS | |
| Special instructions for lifting and supporting vehicle | AH00.60-N-0100-01TS | ||
| 2 | Remove lower engine compartment paneling | If installed. |
AR61.20-D-1105TS |
| 3 | Drain engine oil | ||
| Engine oil and oil filter change | AP18.00-D-0101TS | ||
| 4 | Disconnect electrical connection (1) | ||
| 5 | Remove fill level sensor (3) | If sealing ring is damaged, ↓ Replace sealing ring. |
*BA18.40-N-1001-03TS |
| 6 | Install in the reverse order | ||
| Check | |||
| Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | AS00.00-Z-0005-01A | |
| 7 | Check for leak tightness with engine running |
| Number | Designation | Engine 642 in model 907 | |
|---|---|---|---|
| BA18.40-N-1001-03TS | Screw/bolt, fill level sensor to oil pan bottom section | Nm | 11 |