Perform Basic Setting For Rear Side Window - AR67.30-P-4201-01LWO

Model 238.3

MODIFICATION NOTES

12.07.2019	Bolt, side window to window lifter	Model 238	BA67.30-P-1001-01B
04.04.2021	Side window in soft top/roof edge	Model 238.3	BE67.30-P-1001-03B

CHECK VALUES FOR GAP DIMENSIONS

Number	Designation			Model 238.3
BE60.00-P-1016-01HA	Front door window to rear side window	Dimension "J1"	mm	7, 5 (±1)
BE60.00-P-1016-01HA	Front door window to rear side window	For picture, see		AR60.00-P-0700-01LWO

CHECK VALUES FOR SIDE WINDOWS

Number	Designation			Model 238.3
BE67.30-P-1001-03B	Side window in soft top/roof edge	Dimension "a"	mm	4, 5 (+1/-0, 5)

SIDE WINDOW(S)

Number	Designation		Model 238
BA67.30-P-1001-01B	Bolt, side window to window lifter	Nm	12

SIDE WINDOW(S)

Number	Designation		Model 238
BA67.30-P-1002-01B	Bolt/nut, power window lifter of side windows to inner panel	Nm	13

Fig 1: Identifying Socket Wrench (209 589 00 09 00)

Courtesy of MERCEDES-BENZ USA

The adjustment is realized with the front door closed and fully raised rear side window; a helper is required.

Courtesy of MERCEDES-BENZ USA

Adjustment in x-direction and y-direction

Attach tapes (2) flush with upper edge of rear side window (1) (arrows).
Apply adhesive tapes (2) at large Distance to one another if possible.
Mark dimension "a" on tapes (2).
Completely lower side window (1) and then move to upper end position.
Close front door.
Release screws (4) until rear side window (1) can be moved.
Adjust rear side window (1) from outside with a cup suction tool in x-direction and y-direction.
Adjustment in x-direction:

Align rear side window (1) by means of the dimension "J1" with front side window (3).

Adjustment in y-direction:

Align rear side window (1) by means of dimension "a" with roof edge.
Tighten bolts (4)
Completely lower side window (1) and then move to upper end position.
Open front door and close again.
Check adjustment in x-direction and y-direction again.
In the case of complaints.

↓

repeat adjustment procedure.

Adjustment in Z direction
Loosen nuts (5).
Adjust inclination of rear side window by turning bolts with socket wrench.
When adjusting the front bolt, adjust in same manner on rear bolt.

Otherwise increased seal wear can occur.

The transition of the rear side window to front side window must be flush over entire surface when driver's door or front passenger door is closed.

One complete turn of the bolt results in approx. 1 mm adjustment path in the z-direction.
Screw in nuts (5) with socket wrench.
Screw nuts (5) tight.
Completely lower side window and then move to upper end position.
Open front door and close again.
Check adjustment in z-direction again.
In the case of complaints.

↓

repeat adjustment procedure.
Remove tapes and clean rear side window.

Courtesy of MERCEDES-BENZ USA