000 588 03 19 00 Load Tester - WS15.00-P-0027B

Model all

Used in FG 15/Set B

Purpose:

Load tester for loading the vehicle on-board network for the alternator charge current checking.

Test equipment category CAT_B.

Procurement information:

This criteria catalogue serves to provide support for selection of variants of workshop equipment available on the free market. It just describes the minimum requirement for fulfilling the Mercedes-Benz standard. There is therefore no reference made to manufacturer specific equipment or devices.

NOTE: These testers are not approved by Mercedes-Benz for obtaining findings on the starter battery.

Minimum requirements:

The load tester is suitable for a direct voltage of up to 30 V.
The load allows itself to be set steplessly or in steps of a maximum of 0.5 kW.
The engageable load is at least 2.1 kW for a duty cycle of at least 15 seconds.
The flow of current is interrupted during clamping on and disconnecting the tester on the on-board electrical system.

The usual designations for volt amp(s) tester on the free market include: load tester, Carbon Pile Load, battery tester or electronic load.