LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mercedes Benz >> 2010 >> Sprinter 3500, 2D Cab Chassis Extended >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Description & Operation, General Information, Basic Knowledge, Safety Precautions >> Basic Knowledge >> Detecting Rapid Pressure Loss, Function - GF40.15-D-2004HH
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Detecting Rapid Pressure Loss, Function - GF40.15-D-2004HH

MODEL 906 

Sudden pressure loss 

Driving safety is no longer guaranteed if there is a rapid pressure loss. The driver is requested to stop the vehicle and to check the condition of the tires. It is the driver's responsibility to decide whether to continue the journey at low speed as far as the nearest workshop or whether an on-the-spot repair is necessary (use of TIREFIT or replacement of wheel). Rapid pressure loss is detected if a pressure 0.2 bar is detected within 60 s. While the vehicle is being loss of driven, a warning message on the display (A1p1) of the instrument cluster (A1) informs the driver that a tire is defective.

The warning message is displayed permanently as long as circuit 15 is ON. When circuit 15 is set to ON again, the warning lamp is immediately actuated and the warning is given again after the vehicle has been driven for approx. 5 minutes.

IMPORTANT With the operating condition "fast pressure loss", the tire concerned is highlighted on the display of the instrument cluster.

IMPORTANT The RDK indicator lamp (A1e29) in the instrument cluster is actuated parallel to the "fast pressure loss". It goes out at reactivation or when the tire pressure monitor system has determined that the tire inflation pressure was corrected.

Component description for tire pressure monitor control unit GF40.15-D-5124H 
Wheel antenna, component description GF40.15-D-5125HH 
Wheel sensor, component description GF40.15-D-5126H