ME-SFI two-sensor control, function - GF07.61-P-3020MIS
ENGINE 272.9 in MODEL 221.0 /1 as of model year 2009 / AEJ 08
ENGINE 273.9 in MODEL 216.3, 221.0 /1 as of model year 2009 / AEJ 08
Function requirements for two-sensor control, general points
- Circuit 87M ON (engine control ON)
- Engine running
- Operating temperature of firewall catalytic converters is reached
- Lambda regulation active
- Left and right O 2 sensors downstream of the catalytic converter (G3/5, G3/6) defect-free
Two-sensor control, general points
The two-sensor control is used to monitor the function of the LH and RH O 2 sensors upstream of the catalytic converter (G3/3, G3/4) and the effectiveness of the firewall catalytic converter.
To do this, the ME-SFI [ME] control unit (N3/10) reads the following sensors:
- LH and RH O2 sensors upstream of CAT, signals from oxygen sensors upstream of CAT (catalytic converter)
- LH and RH O2 sensors downstream of CAT, signals from oxygen sensors downstream of catalytic converter
Function sequence for two-sensor control
The ME-SFI [ME] control unit determines the lambda mean value using the signals from the oxygen sensors downstream of the catalytic converter. This value is compared with a stored value for optimum exhaust emissions.
If the deviation is too large after a number of measurements, a correction value is determined for the lambda control.
Using the correction value (value with new LH and RH O 2 sensors upstream of CAT is about 0), the aging of the O 2 sensors upstream of CAT is adjusted within certain limits.
If the correction value exceeds the specified limit value, the O 2 sensors upstream of the catalytic converter must be replaced. The correction value depends on the performance map, and is applied by the ME-SFI [ME] control unit by adapting the injection time of the fuel injection valves (Y62).
If the specified limit value is exceeded or if the oxygen sensor signals (upstream or downstream of CAT) fail the plausibility check, the ME-SFI [ME] control unit actuates the engine diagnosis indicator lamp on the instrument cluster (A1) (A1e58) over the chassis CAN (CAN E) and central CAN (CAN F).
The exceeded limit value is stored in the fault memory by the ME-SFI [ME] control unit and can be read out and deleted using the Diagnosis Assistance System (DAS).
| Electrical function schematic for two-sensor control ME | Model 216 | PE07.61-P-2763-97CAB | |
| Model 221 | PE07.61-P-2763-97SAB | ||
| Component description for ME-SFI [ME] control unit | N3/10 Engine 272 except 272.974 (Hybrid) |
GF07.61-P-6000MIS | |
| N3/10 Engine 272.974 (Hybrid) |
GF07.61-P-6000MEH | ||
| N3/10 Engine 273 |
GF07.61-P-6000MLS |