July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Initial Programming Of Engine Control Module: Notes

WARNING: This page is about a different car, the 1996 Mercedes-Benz C220, 1995 Mercedes-Benz C220, and 1994 Mercedes-Benz C220. However, it is still accessible from the selected car via links, so may be relevant.

Prerequisite for initial programming process:

Battery Voltage

11 Volt Minimum

Vehicle Speed Signal

V = 0

Engine RPM Signal

n = 0

Transmission Range

P/N = 1

CAUTION: Vehicle can not be moved during initial programming process.

Idle Speed Contact Closed
CTP = 1

NOTE: Only then will the transmission be recognized.

Drive Vehicle
V = > 3 mph (5 km/h)