Steering Wheel: Installation

Position steering wheel onto shaft splines, aligning index marks made during removal, and aligning turn signal canceling cam on steering shaft with combination switch tang. Install steering wheel.
Install a NEW hub nut and tighten to 60 ft. lbs. (80 N.m). Connect horn electrical connectors. Install air bag module. See AIR BAG MODULE . Connect horn wiring. Activate SRS and perform system operation check to ensure system is functioning properly. See DISABLING & ACTIVATING AIR BAG SYSTEM .
On vehicles equipped with Adaptive Damping System (ADS), steering wheel angle sensor MUST BE reactivated by starting engine then turning steering wheel lock to lock.