Parameters

After programming the vehicle equipment, the SRS MIL (A1e15) will continue to blink, indicating the need to set the parameters on the SRS control module (N2/2). Currently, the parameter set is identical for all models.

The setting of the parameters can only be accomplished with the Hand-Held Tester (HHT).

CAUTION: To avoid damaging the SRS control module (N2/2), DO NOT interrupt the voltage supply to the control module while setting the parameters. Setting of parameters can only be performed once.

NOTE: After programming and setting SRS control module parameters, the SRS MIL (A1e15) will go out.