Supplementary Work When Installing Modified Control Unit (1/3)

NOTE: After the installation of a modified airbag control unit (airbag 1/3) part no. 004 820 11 10 supplementary jobs will be necessary:

Table:

1. In addition to modified control unit install either line A or line B (table) depending on what control unit was installed in the vehicle.
2. Additional work:





- Remove voltage transformer (N24) (not present in all vehicles) and insulate plug connector (3). Service and Repair
- Remove reserve power source (C1) and insulate plug connector (2). Service and Repair
- Fasten cables to existing cable harness using cable straps.
- Test airbag system using airbag tester, part no. 126 589 10 21 00.