Power Steering Gear: Installation
Replace lock nuts and bolts. To install steering gear, reverse removal procedure and tighten to specifications. Fill system with recommended fluid.
SPECIFICATIONS
| Steering Wheel Free Play | 1" maximum | |
| Power Steering Pump | ||
| Circulation Pressure | 28.4-71 psi | |
| Pressure Relief Valve Opening Pressure | 71 psi | |
| Number of Balls in lall Circuit | 24 | |
| End Play of Pump Shaft - New | .028" maximum | |
| Used | .039" maximum | |
TIGHTENING SPECIFICATIONS
| Application | Ft. Lbs. (mkg) |
|---|---|
| Steering Gear-to-Frame | 43 (6.0) |
| Pitman Arm-to-Pitman Shaft | 116-145 (16.0-19.0) |
| Linkage Ball Pin Nuts | 25 (3.5) |
| Slotted Nut-to-Bearing Cap | 87-101 (12.0-14.0) |
| Bearing Cap-to-Steering Gear | 43-47 (6.0-6.5) |
| Adjusting Screw Nut | 22-25 (3.0-3.5) |
| Idler Arm-to-Frame | 87 (12.0) |
| Pump Shaft Nut | 43 (6.0) |
| Pump Housing Bolts | 25-29 (3.5-4.0) |