October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Perform Verification After Relay And Fuse Block Replacement
- Temporarily connect the negative lead-acid battery terminal and verify that the related wiring harness is not heated.
- Switch the main power ON (READY off).
- Verify that a fuse is not blown and the related wiring harness is not heated.
- Inspect for DTCs.
- If a DTC is displayed, repair the malfunctioning location according to the applicable DTC troubleshooting.
- After completion of repairs, clear all DTCs stored in the module.
- If there is no malfunction in Steps 1, 3 and 4, switch the main power ON (READY ON).
- Operate all the switches of the interior/exterior lights of the vehicle and verify that all the light bulbs turn on or flash.
- Operate the audio, A/C, wiper switch, and the selector lever and verify that they are all operating normally.
- Switch to Sport mode and start the engine.
- Shift the selector lever to the P position and race the engine at approx. 3, 000 rpm from idle to verify that there is no malfunction.
- Perform a road test to verify that there are no low speed, acceleration and shift-up, shift-down malfunctions.