Procedure Not Using M-MDS

CAUTION:

Perform Steps 4- 5 within 30 s.

Empty the vehicle except for the jack and vehicle tools.
Adjust the tire pressure to the standard. (See WHEEL AND TIRE SPECIFICATION .)
Move the vehicle to level ground.
Switch the ignition ON (engine off or on).
NOTE:
- The LED headlight warning light continues flashing during the first initial setting, however, continue the work because it does not indicate an improper procedure.
Courtesy of MAZDA MOTORS CORP.
CAUTION:
- If the terminals are mistakenly connected, vehicle damage or fire could occur. When connecting with the jumper wire, thoroughly verify what terminals are being connected to prevent a miss-connection.
Using jumper wires, connect terminal B and terminal J (GND) of DLC-2 three times at 0.5-1.5 s intervals as shown in the figure below.

Courtesy of MAZDA MOTORS CORP.

Verify the LED headlight warning light.

If the LED headlight warning light flashes three times at 0.25 s intervals and turns off as shown in the figure below, it indicates that the headlight auto leveling system initialization is complete. Go to the next step.

Courtesy of MAZDA MOTORS CORP.

If the LED headlight warning light flashes at intervals of 0.25 s, the servicing may not have completed normally, so start over from Step 5.
If the LED headlight warning light turns on, the headlight auto leveling system may have a malfunction. Perform DTC inspection. (See DTC INSPECTION .)
- Repair or replace the malfunctioning location, then repeat the procedure from Step 4.

Perform the headlight aiming adjustment. (See HEADLIGHT AIMING .)