September 30: LEMON manuals is back up on a temporary server! Slowness is possible
SUNVISOR Removal/Installation
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION [(US)]
.)
- Insert a tape-wrapped flathead screwdriver into the position shown in the figure below.
 Courtesy of MAZDA MOTORS CORP.
|
- Move the tape-wrapped flathead screwdriver in the direction of the arrow shown in the figure below, detach the tab, and remove the sunvisor cap.
 Courtesy of MAZDA MOTORS CORP.
|
- Remove the screw.
 Courtesy of MAZDA MOTORS CORP.
|
- Move the sunvisor in the direction of the arrow shown in the figure below and detach the hook.
 Courtesy of MAZDA MOTORS CORP.
|
- Disconnect the vanity mirror illumination connector.
- When removing the center adapter, perform the following procedure:
- Using a tape-wrapped flathead screwdriver, press the center adapter tab in the direction of arrow (1) shown in the figure below, and remove the center adapter in the direction of arrow (2).
 Courtesy of MAZDA MOTORS CORP.
|
- Install in the reverse order of removal.