Power Window System Initialization Procedure
NOTE:
- If the following operations have been performed, the initial settings are reset, and auto operation is disabled. Therefore, performing the initial setting is necessary.
- Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
- Disconnect the power window main switch connector.
- Remove the power window system power supply fuse.
- Disconnect the power window subswitch connector.
- Switch the ignition ON (engine off or on).
- Press each power window main switch or power window subswitch to fully open the door glass.
- Pull up and hold each power window main switch or power window subswitch until the door glass is fully closed. Once fully closed, keep holding the switch up for approx. 2 s or more.