October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Brake Fluid Pressure Sensor Inspection
- Switch the ignition off.
- Disconnect the brake pipe from the LF brake hose.
 Courtesy of MAZDA MOTORS CORP.
|
- Install the SSTs to the brake pipe as shown in the figure.
 Courtesy of MAZDA MOTORS CORP.
|
- Bleed the brake line and the SSTs of air. Bleed the air form the SSTs using bleeder screw A.
- Connect the M-MDS to the DLC-2.
- Select the "BRK_F_P_R" PID.
- Start the engine.
- Depress the brake pedal, and confirm that the fluid pressure value of the SST (gauge) and the value shown on the M-MDS are equal.
- After the inspection, remove the SSTs, install the brake hose and brake pipe to the original positions. (See FRONT BRAKE HOSE REMOVAL/INSTALLATION
.)
- Bleed the air from the brake line. (See BRAKE FLUID AIR BLEEDING
.)