LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2019 >> CX-5 Sport, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System (VIN 2)) >> Engine Coolant Temperature (ECT) Sensor Removal/Installation >> ECT sensor No. 2
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

ECT sensor No. 2

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
  2. Remove the front under cover No. 1. (See FRONT UNDER COVER NO. 1 REMOVAL/INSTALLATION .)
  3. Remove the front under cover No. 2. (See FRONT UNDER COVER NO. 2 REMOVAL/INSTALLATION .)
  4. Disconnect the water hose.
    G13119199Courtesy of MAZDA MOTORS CORP.
  5. Disconnect the charge air cooler outlet hose (intake shutter valve side). (See INTAKE-AIR SYSTEM REMOVAL/INSTALLATION .)
  6. Disconnect the ECT sensor No. 2 connector.
    Fig 1: ECT Sensor No. 2 Connector, Clip And Bolt With Torque Specification
    G13119200Courtesy of MAZDA MOTORS CORP.
  7. Remove the bolt.
  8. Remove the clip.
  9. Remove the water pipe and ECT sensor No. 2 as a single unit.
    Fig 2: ECT Sensor No. 2 Bolt With Torque Specification
    G13119201Courtesy of MAZDA MOTORS CORP.
  10. Remove the ECT sensor No. 2.
  11. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals