Illumination Light Inspection

NOTE:

The illumination light is built into the AUTO HOLD switch. If there is any malfunction, replace the electric parking brake switch.

Disconnect the negative battery terminal. (See NEGATIVE BATTERY TERMINAL DISCONNECTION/CONNECTION .)
Remove the electric parking brake switch. (See ELECTRIC PARKING BRAKE SWITCH REMOVAL/INSTALLATION .)
Apply battery positive voltage to electric parking brake switch terminal I, and connect terminal J to ground.

Fig 1: Electric Parking Brake Switch Connector Terminals
Courtesy of MAZDA MOTORS CORP.
Verify that the illumination light turns on.

Fig 2: Locating Auto Hold Illumination Light
Courtesy of MAZDA MOTORS CORP.
- If there is any malfunction, replace the electric parking brake switch.