LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2017 >> CX-3 Touring, AWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine Mechanical System >> Timing Chain Removal/Installation >> Engine Front Cover Removal Note
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Engine Front Cover Removal Note

  1. Remove the nut shown in the figure and set the cooler hose (LO) aside.
    Fig 1: Cooler Hose (Low) And Nut
    G11437313Courtesy of MAZDA MOTORS CORP.
  2. Remove the insulator shown in the figure.
    Fig 2: Insulator And Nut
    G11437314Courtesy of MAZDA MOTORS CORP.
  3. Set the ground cable and wiring harness bracket shown in the figure aside.
    Fig 3: Ground Cable And Wiring Harness Bracket With Bolts
    G11437315Courtesy of MAZDA MOTORS CORP.
  4. Remove the engine front cover installation bolts.
  5. Using a screwdriver wrapped in a cloth, peel the sealant away a little at a time, and remove the engine front cover.
    CAUTION:
    • Do not apply excessive force to the screwdriver. Otherwise, the engine front cover could be damaged.
    • Be careful not to scratch or damage the seal surface. Otherwise, it could cause oil leakage.
Fig 4: Peeling Sealant Using Screwdriver Wrapped In Cloth
G09785099Courtesy of MAZDA MOTORS CORP.
Fig 5: Removing Engine Front Cover
G11429951Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals