DTC Table
NOTE:
- The security indicator light flashes or illuminates under the following conditions when the ignition is off or ACC.
- There is a malfunction:
- DTC 16 or below: Flashes for approx. 1 min and the DTC flash pattern indicated in the table below repeats 10 times.
- DTC 21 or higher: Illuminates for approx. 1 min and the DTC flash pattern indicated in the table below repeats 10 times.
- If more than one DTC is detected, only the DTC with the lowest number is displayed.
- There is no malfunction:
- The security indicator light illuminates for approx. 3 sand then turns off.
x: Applicable-: Not applicable
| DTC | Warning/indicator light | Description | Fail-safe function | Drive cycle | Self test type(2) | Memory function | Refer to | |||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
| M-MDS display(1) | Security indicator light flashing pattern | |||||||||||||
| Instrument cluster | PCM | |||||||||||||
| B10D9:87 | P1260:00 | 1 1 |
- | Communication error with coil antenna | - | - | (See SECURITY INDICATOR LIGHT: 11, DTC: B10D9:87/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||||
| B10D5:13 | P1260:00 | 1 2 |
Coil antenna malfunction | - | - | - | (See SECURITY INDICATOR LIGHT: 12, DTC: B10D5:13/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||||
| B10D7:05 | P1260:00 | 1 3 |
- | Key ID number programming error | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 13, DTC: B10D7:05/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||
| B10D7:94 | P1260:00 | - | Key ID number reading error | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 13, DTC: B10D7:94/P1260:00 [IMMOBILIZER SYSTEM] .) | ||||||
| B10D7:81 | P1260:00 | 1 4 |
- | Receiving erratic serial data | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 14, DTC: B10D7:81/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||
| B10D7:51 | P1260:00 | 1 5 |
- | Unprogrammed key ID number | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 15, DTC: B10D7:51/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||
| U0100:87 | P1260:00 | 1 6 |
Communication error between instrument cluster and PCM (No response) | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 16, DTC: U0100:87/P1260:00 [IMMOBILIZER SYSTEM] .) | ||||||
| B10D8:00 | P1260:00 | 2 1 |
- | Shortage of programmed key | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 21, DTC: B10D8:00/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||
| B10DA:51 | P1260:00 | 2 2 |
- | Communication error to PCM (Data transfer failure) | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 22, DTC: B10DA:51/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||
| B10DA:62 | P1260:00 | 2 3 |
- | Communication error to PCM (Data mismatch) | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: 23, DTC: B10DA:62/P1260:00 [IMMOBILIZER SYSTEM] .) | |||||
| U0001:88 | U0073:00 | - | - | CAN system communication error (HS-CAN) | - | - | C, D | - | (See SECURITY INDICATOR LIGHT: -, DTC: U0001:88/U0073:00 [IMMOBILIZER SYSTEM] .) | |||||
| U0100:00 | - | - | Illuminate (Check engine light/Charging system warning light) | Communication error to PCM | - | - | C, D | x | (See SECURITY INDICATOR LIGHT: -, DTC: U0100:00/- [IMMOBILIZER SYSTEM] .) | |||||
| U3000:41 | - | - | - | Instrument cluster internal malfunction | - | - | C, D | - | (See DTC U3000:41 [INSTRUMENT CLUSTER] .) | |||||
|
||||||||||||||