DTC P0748-00: Pressure Control Solenoid Circuit Malfunction: Notes

DTC P0748:00	Pressure control solenoid circuit malfunction
DETECTION CONDITION	Under the following condition, the TCM detects the pressure control solenoid circuit malfunction: Battery voltage is 10.5 V or more . Diagnostic support note The check engine light illuminates if the TCM detects the above malfunction condition during the first drive cycle. The automatic transaxle warning light illuminates if the TCM detects the above malfunction condition during the first drive cycle. PENDING CODE is available. FREEZE FRAME DATA is available. DTC is stored in the TCM memory.
FAIL-SAFE FUNCTION	Set to emergency mode. Inhibits learning control. Inhibits manual mode. Inhibits neutral idle control. Inhibits AAS.
POSSIBLE CAUSE	Short or open circuit in pressure control solenoid circuit Pressure control solenoid malfunction
SYSTEM WIRING DIAGRAM	Not applicable