October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.
Two-Step Deployment Control System
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION
.)
- Disconnect the negative battery cable and wait for 1 min or more
.
- Remove the driver-side air bag module. (See DRIVER-SIDE AIR BAG MODULE REMOVAL/INSTALLATION [TWO-STEP DEPLOYMENT CONTROL SYSTEM] .)
- Disconnect the clock spring connector (part wiring harness-side).
- Inspect for resistance and continuity between clock spring connector terminals 5D and 5F (part wiring harness-side) using a tester.
Courtesy of MAZDA MOTORS CORP.
Courtesy of MAZDA MOTORS CORP.
| Switch condition |
Resistance (ohm) |
| Cruise OFF switch held at on |
Continuity |
| CANCEL switch held at on |
118.8-121.2 |
| SET (-) switch held at on |
297.0-303.0 |
| SET (+) switch held at on |
594.0-606.0 |
| RESUME switch held at on |
1, 098.9-1, 121.1 |
| Cruise ON switch held at on |
2, 088.9-2, 131.1 |
| Neutral |
4, 266.9-4, 353.1 |
- Apply battery positive voltage to clock spring terminal 5O (part wiring harness-side) and terminal 5E (part wiring harness-side) to ground.
Courtesy of MAZDA MOTORS CORP.
- Verify that the LED illuminates.