LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2014 >> 3 Sport, 4D Hatchback, Automatic Trans >> Repair and Diagnosis >> Brakes >> Traction Control >> Dynamic Stability Control System >> DSC Related Parts Sensor Initialization Procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

DSC Related Parts Sensor Initialization Procedure

WARNING:
  • If the initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing the DSC HU/CM or SAS control module, always perform the initialization procedure to insure proper DSC operation.
  1. Inspect the wheel alignment and the tire pressure.
    • If there is any malfunction, adjust the applicable part.
  2. Position the vehicle on level ground.
  3. Switch the ignition off.
  4. Connect the M-MDS (IDS) to DLC-2.
  5. After the vehicle is identified, select the following items from the initial screen of the IDS.
    1. Select "Chassis".
    2. Select "ABS/DSC".
    3. Select "Sensor Initialization".
  6. Then, select an item from the screen menu.
    • "Brake fluid pressure sensor"
    • "Lateral Acceleration Sensor"
    • "Yaw Rate Sensor"
    • "Longitudinal Acceleration Sensor"
  7. Perform the procedure according to the directions on the screen.
  8. Drive the vehicle.
  9. After 5 min or more  of driving, verify that the DSC system is normal.
scientia non olet · About LEMON Manuals