Diagnostic Procedure

DTC U0433:00 (DYNAMIC STABILITY CONTROL) - DIAGNOSTIC PROCEDURE

STEP	INSPECTION		ACTION
1	INSPECT FOR LASER SENSOR MALFUNCTION Switch the ignition to off. Using the M-MDS, perform the DTC inspection for the laser sensor. (See ON-BOARD DIAGNOSIS [LASER SENSOR] .) Are any DTCs detected?	Yes	Go to applicable DTC inspection. (See ON-BOARD DIAGNOSIS [LASER SENSOR] .)
1		No	Go to the next step.
2	VERIFY THAT THE SAME DTC IS NOT PRESENT Clear the DTCs from the memory. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .) Are the same DTCs present?	Yes	Repeat the inspection from Step 1. If the malfunction recurs, replace the laser sensor, then go to the next step. (See LASER SENSOR REMOVAL/INSTALLATION .)
2		No	Go to the next step.
3	VERIFY THAT NO OTHER DTCS ARE PRESENT Are any other DTCs output?	Yes	Go to the applicable DTC inspection. (See ON-BOARD DIAGNOSIS [DYNAMIC STABILITY CONTROL (DSC)] .)
3		No	DTC troubleshooting completed.