Clutch Pedal Position (CPP) Switch Inspection
- Verify that the CPP switch is installed properly.
- Remove the battery cover. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
- Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZR 2.5] .)
- Disconnect the CPP switch connector.
- Inspect for continuity between CPP switch terminals A and B.
- If not as specified, replace the CPP switch. (See CLUTCH PEDAL POSITION SWITCH REMOVAL/INSTALLATION .)
CLUTCH PEDAL POSITION SPECIFICATION
| Measured Condition | Clutch Pedal Position | Continuity |
|---|---|---|
| Rod pushed | Clutch pedal released | Continuity detected |
| Except above | Clutch pedal depressed | No continuity |