Flywheel Installation Note
- Clean the crankshaft thread holes.
- Install the flywheel to the crankshaft.
- Hand-tighten the new flywheel lock bolts.
- Install the SST to the flywheel.
- Temporarily tighten the lock bolts uniformly in the order of the numbers shown in the figure and install the flywheel.
- Tighten the lock bolts in three steps in the order shown in the figure.
Tightening torque
- Tighten the lock bolts in three steps.
- 1st: 46-54 N.m {4.7-5.5 kgf.m, 34-39 ft.lbf}
- 2nd: 76-84 N.m {7.8-8.5 kgf.m, 57-61 ft.lbf}
- 3rd: 108-116 N.m {11.1-11.8 kgf.m, 80-85 ft.lbf}