July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!
DTC P0500:00: Notes
DTC P0500:00
VSS circuit problem
DETECTION CONDITION
If an error in the wheel speed signal from the DSC HU/CM is detected by CAN when the following conditions are met:
MONITORING CONDITIONS
Neutral switch and CPP switch: OFF (MTX)
Shift range: except P, N or R position (ATX)
Absolute load: above 40 %
Engine speed: above 2,000 rpm
Brake switch: OFF
Vehicle speed: below 3.76 km/h {2.34 mph}
Diagnostic support note
This is a continuous monitor (CCM).
The MIL illuminates if the PCM detects the above malfunction condition in two consecutive drive cycles or in one drive cycle while the DTC for the same malfunction has been stored in the PCM.
PENDING CODE is available if the PCM detects the above malfunction condition during the first drive cycle.
FREEZE FRAME DATA (Mode 2)/Snapshot data is available.