Camshaft Position (CMP) Sensor Removal/Installation - 2.5L

Fig 1: Camshaft Position (CMP) Sensor Replacement Components With Torque Specifications (2.5L)

Courtesy of MAZDA MOTORS CORP.

Disconnect the camshaft position (CMP) sensor electrical connector.
Remove the bolt and the CMP sensor.
- To install, tighten to 7 N.m {0.7 kgf.m, 62 in.lbf}.
- Inspect the O-ring seal and install new as necessary.
To install, reverse the removal procedure.
NOTE:
- Lubricate the CMP sensor O-ring seal with clean engine oil.