Resistance Inspection

1. Disconnect the eccentric shaft position sensor connector.
2. Measure the coil resistance between eccentric shaft position sensor terminals A and B.

• If not within the specification, replace the eccentric shaft position sensor. (See ECCENTRIC SHAFT POSITION SENSOR REMOVAL/INSTALLATION .)
• If the monitor item condition/specification (reference) is not within the specification, even though the eccentric shaft position sensor resistance is within the specification, perform the "Circuit Open/Short Inspection" and repair or replace the malfunctioning part. (See CIRCUIT OPEN/SHORT INSPECTION .)

Eccentric shaft position sensor resistance 950-1, 250 ohms [at room temperature]