Crankshaft Position (CKP) Sensor Removal/Installation

NOTE:

Disconnect the connector after the CKP sensor is removed to prevent the CKP sensor from falling off.
The bolt and sensor are integrated and cannot be pulled out.
When removing the CKP sensor, be careful not to drop the tool.
The bolt and sensor must be pulled in different directions. Pull them as indicated in the illustration.

Fig 1: Identifying CKP Sensor
Courtesy of MAZDA MOTORS CORP.

Disconnect the negative battery cable. (See BATTERY REMOVAL/INSTALLATION [MZI-3.7] .)
Remove the Catalytic Converter (WU-TWC) (LH) for easier access. (See EXHAUST SYSTEM REMOVAL/INSTALLATION .)
Remove in the order indicated in the illustration.

Fig 2: CKP Sensor Replacement Components With Torque Specifications
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.