Neutral Switch Removal/Installation
- Disconnect the negative battery cable.
- Disconnect the neutral switch connector.
- Remove the aerodynamic undercover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION ).
- Remove the neutral switch with the gasket.
- Install a new gasket and the neutral switch to the transaxle case.
Tightening torque
29-39 N.m {3.0-3.9 kgf.m, 22-28 ft.lbf}
- Install the aerodynamic under cover No. 2. (See AERODYNAMIC UNDER COVER NO. 2 REMOVAL/INSTALLATION ).
- Connect the neutral switch connector.
- Connect the negative battery cable.