Symptom Troubleshooting [Engine]
- Symptom Troubleshooting Wiring Diagram [13B-MSP]
- Symptom Diagnostic Index [13B-MSP]
- Quick Diagnostic Chart [13B-MSP]
- Foreword [13B-MSP]
- No. 1 MELTING OF MAIN OR OTHER FUSES [13B-MSP]
- No. 2 MIL ILLUMINATES [13B-MSP]
- No. 3 WILL NOT CRANK [13B-MSP]
- No. 4 HARD TO START/LONG CRANK/ERRATIC START/ERRATIC CRANK [13B-MSP]
- No. 5 ENGINE STALLS-AFTER START/AT IDLE [13B-MSP]
- No. 6 CRANKS NORMALLY BUT WILL NOT START [13B-MSP]
- No. 7 SLOW RETURN TO IDLE [13B-MSP]
- No. 8 ENGINE RUNS ROUGH/ROLLING IDLE [13B-MSP]
- No. 9 FAST IDLE/RUNS ON [13B-MSP]
- No. 10 LOW IDLE/STALLS DURING DECELERATION [13B-MSP]
- No. 11 ENGINE STALLS/QUITS, ENGINE RUNS ROUGH, MISSES, BUCK/JERK, HESITATION/STUMBLE, SURGES [13B-MSP]
- No. 12 LACK/LOSS OF POWER-ACCELERATION/CRUISE [13B-MSP]
- No. 13 KNOCKING/PINGING/DETONATION-ACCELERATION/CRUISE [13B-MSP]
- No. 14 POOR FUEL ECONOMY [13B-MSP]
- No. 15 EMISSION COMPLIANCE [13B-MSP]
- No. 16 HIGH OIL CONSUMPTION/LEAKAGE [13B-MSP]
- No. 17 COOLING SYSTEM CONCERNS-OVERHEATING [13B-MSP]
- No. 18 COOLING SYSTEM CONCERNS-RUNS COLD [13B-MSP]
- No. 19 EXHAUST SMOKE [13B-MSP]
- No. 20 FUEL ODOR (IN ENGINE COMPARTMENT) [13B-MSP]
- No. 21 ENGINE NOISE [13B-MSP]
- No. 22 VIBRATION CONCERNS (ENGINE) [13B-MSP]
- No. 23 A/C DOES NOT WORK SUFFICIENTLY [13B-MSP]
- No. 24 A/C IS ALWAYS ON OR A/C COMPRESSOR RUNS CONTINUOUSLY [13B-MSP]
- No. 25 A/C IS NOT CUT OFF UNDER WIDE OPEN THROTTLE CONDITIONS [13B-MSP]
- No. 26 EXHAUST SULPHUR SMELL [13B-MSP]
- No. 27 FUEL REFILL CONCERNS [13B-MSP]
- No. 28 FUEL FILLING SHUT OFF CONCERNS [13B-MSP]
- No. 29 SPARK PLUG CONDITION [13B-MSP]
- Intermittent Concern Troubleshooting [13B-MSP]
- Engine Control System Operation Inspection [13B-MSP]
- Input Signal System Investigation Procedure
- Notes
- Finding Unusual Signals
- Locating The Source Of Unusual Signals
- Hall Or Piezo-Electric Type (TP Sensor, APP Sensor And BARO Sensor)
- Investigate The Input Signal System For Hall Or Piezo-Electric Type
- Investigate The Standard Power Supply System For Hall Or Piezo-Electric Type
- Investigate The Gnd System For Hall Or Piezo-Electric Type
- Hot Wire Type (Fuel Tank Level Sensor And Mass Air Flow (MAF) Sensor)
- Investigate The GND System For Hot Wire Type
- Investigate The Input Signal System For Hot Wire Type
- Investigate The Electrical Supply System For Hot Wire Type
- Thermistor Type (IAT Sensor And ECT Sensor)
- Investigate The Input Signal System For Thermistor Type
- Investigate The GND System For Thermistor Type
- Main Relay Operation Inspection
- Intake Manifold Vacuum Inspection
- Drive-by-wire Control System Inspection
- Variable Dynamic Effect Intake-air (VDI) Operation Inspection (13B-MSP(high-power))
- Secondary Shutter Valve (SSV) Operation Inspection
- Auxiliary Port Valve (APV) Control Inspection
- Jet Air Fuel Mixing System Operation Inspection
- Fuel Injector Operation Inspection
- Fuel Pump Operation Inspection
- Fuel Pump Control System Inspection
- Fuel Pump Speed Control Operation Inspection
- Spark Test
- Cooling Fan Control System Inspection
- Secondary Air Injection (AIR) System Inspection
- Metering Oil Pump Control Inspection
- Purge Control System Inspection
- Variable Fresh Air Duct (VFAD) Control System Operation Inspection
- Evaporative Emission (EVAP) System Leak Inspection
- Rotor Balance Test
- Input Signal System Investigation Procedure