LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2009 >> B2300 Standard >> Repair and Diagnosis >> General Information >> OBD-II Drive Cycles >> Drive Cycles >> 2005-08: RX-8 >> Mode 6 (EVAP System Repair Verification Drive Mode)
September 30: LEMON manuals is back up on a temporary server! Slowness is possible

Mode 6 (EVAP System Repair Verification Drive Mode)

NOTE: If the Mode 6 cannot be performed (you cannot drive the vehicle under the Mode 6 condition), perform the "Evaporative System Test" as an alternative. (See EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK INSPECTION.)
NOTE: If the Mode 6 cannot be performed (you cannot drive the vehicle under the Mode 6 condition), perform the "Evaporative System Test" as an alternative. (See EVAPORATIVE EMISSION (EVAP) SYSTEM LEAK INSPECTION.)
  1. Drive the vehicle as shown in the graph. The driving condition before driving at constant speed is not specified.
    Fig 1: Identifying Drive Vehicle As Shown In Graph
    G03701653Courtesy of MAZDA MOTORS CORP.
  2. Stop the vehicle and access the ON BOARD SYSTEM READINESS to inspect the Drive Mode completion status.
    • If completed, RFC changes from No to Yes.
    • If not completed, turn the ignition switch off, then go back to Step 1.
  3. Access the DIAGNOSTIC MONITORING TEST RESULTS to inspect the monitor results.
    • If detect values are not within specification, repair has not been completed.
  4. Verify that no DTCs are available.
scientia non olet · About LEMON Manuals