DTC Display

Connect the M-MDS to the DLC-2 connector.
After the vehicle is identified, select the following items from the initial screen of the M-MDS.
- When using the IDS (laptop PC)
  - Select the "Toolbox" tab.
  - Select "Self Test".
  - Select "Modules".
  - Select "RCM".
- When using the PDS (Pocket PC)
  - Select "Module Tests".
  - Select "RCM".
  - Select "Self Test".
Verify the DTC according to the directions on the screen.
- If any DTCs are displayed, perform troubleshooting according to the corresponding DTC inspection.
After completion of repairs, clear all DTCs stored in the SAS control module. (See CLEARING DTC .)

Fig 1: Identifying DLC-2 Connector
Courtesy of MAZDA MOTORS CORP.