LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Mazda >> 2007 >> 6 Mazdaspeed >> Repair and Diagnosis >> Engine Performance >> System >> On-Board Diagnostic [Engine Control System L3 With TC] >> DTC P2127 >> Diagnostic procedure
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Diagnostic procedure

DTC P2127 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has the FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on the repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or online repair information availability.
  • Is any related repair information available?
 Yes Perform the repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 CLASSIFY APP SENSOR OR HARNESS MALFUNCTION 
  • Connect the WDS or equivalent.
  • Access the APP2 PID.
  • Disconnect the throttle body connector.
  • Connect a jumper wire between APP sensor terminals A and C (harness-side).
  • Is the PID approx. 100%? 
 Yes Go to the next step.
No Go to step 5.
4 INSPECT APP SENSOR 
 Yes Inspect for poor APP sensor connector terminal A connection. Repair or replace if necessary, then go to Step 8.
No Replace the APP sensor, then go to Step 8.
5 INSPECT POWER SUPPLY CIRCUIT VOLTAGE AT APP SENSOR CONNECTOR 
  • Turn ignition switch to the ON position (Engine off).
  • Measure the voltage at APP sensor terminal A (harness-side).
  • Is the voltage within 4.5-5.5 V? 
 Yes Go to the next step.
No Repair or replace for an open circuit between APP sensor connector terminal A and PCM connector terminal 2K (harness-side).
Then, then go to Step 8.
6 VERIFY APP2 SIGNAL CIRCUIT FOR OPEN CIRCUIT 
  • Turn the ignition switch to off.
  • Inspect for continuity between APP sensor terminal C (harness-side) and PCM terminal 2A (harness-side).
  • Is there continuity?
 Yes Go to the next step.
No Repair or replace the suspected wiring harness, then go to Step 8.
7 VERIFY APP2 SIGNAL CIRCUIT FOR SHORT TO GROUND 
  • Inspect for continuity between APP sensor terminal C (harness-side) and body ground.
  • Is there continuity?
 Yes Repair or replace the suspected wiring harness, then go to the next step.
No Go to the next step.
8 VERIFY TROUBLESHOOTING OF DTC P2127 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn ignition switch to the ON position (Engine off).
  • Clear the DTC from the PCM memory using the WDS or equivalent.
  • Start engine and warm it up completely.
  • Is the same DTC present?
 Yes Replace the PCM, then go to the next step.
(See PCM REMOVAL/INSTALLATION ).
No Go to the next step.
9 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.
scientia non olet · About LEMON Manuals