September 30: LEMON manuals is back up on a temporary server! Slowness is possible
Continuity Inspection
- Remove the neutral switch. (See
NEUTRAL SWITCH REMOVAL/INSTALLATION
.)
- Verify that the continuity between neutral switch terminals A and B is as indicated in the table.
- If it can be verified, perform the "CIRCUIT OPEN/SHORT INSPECTION ".
- If it cannot be verified, replace the neutral switch.
CONTINUITY REFERENCE
| Measured condition |
Continuity |
| Rod pushed |
Continuity detected |
| Except above |
No continuity |
Courtesy of MAZDA MOTORS CORP.